LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Land Rover >> 2012 >> LR4 HSE Lux >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Rear Disc Brake >> Rear Disc Brake >> Removal And Installation >> Brake Caliper >> Removal

Brake Caliper: Removal

NOTE: RH illustration shown, LH is similar.
    WARNING: Make sure to support the vehicle with axle stands.
  1. Raise and support the vehicle.
  2. Remove the wheel and tire.
    3. CAUTION: The brake pad wear indicator sensor is easily damaged. Do not use a lever to remove the sensor. Use fingers only.
  3. RH side only: Disconnect the brake pad wear indicator sensor.
    • Release from the clip.
    GJ0013167
    4. NOTE: Note the orientation of the brake pads.
  4. Remove the brake pads. See Brake Pads .
    5. CAUTION: Before disconnecting or removing components, ensure the area around the joint faces and connections are clean. Plug open connections to prevent contamination.
  5. Disconnect the brake hose from the brake caliper.
    • Remove the union.
    • Remove and discard the two sealing washers.
    • Install blanking caps to the exposed ports.
    GJ0013172
    6. NOTE: Use an additional wrench to prevent the component from rotating.
  6. Remove the brake caliper housing.
    • Remove the brake caliper upper bolt.
    GJ0013173
scientia non olet · About LEMON Manuals