Parking Brake Cable LH: Installation
- Install the LH parking brake cable.
- LH cable: Screw the cable in 5 complete turns.
- Tighten the retaining nut.
- Locate and secure the LH parking brake cable.
- Tighten the bolts to 22 Nm (16 lb.ft).
- Secure the wiring harness.
- Secure the cable grommet to the integrated body frame bracket.
- Connect the parking brake cable to the wheel hub.
- Connect the cable to the brake shoe lever.
- Locate the cable to the backplate.
- Tighten the nut to 8 Nm (6 lb.ft).
- Install the LH rear brake disc.
- Tighten the Torx screw to 35 Nm (26 lb.ft).
- Secure the LH rear brake caliper.
- Remove and discard the tie strap.
- Tighten the bolts to 115 Nm (85 lb.ft).
- Adjust the parking brake shoes. See PARKING BRAKE SHOE AND LINING ADJUSTMENT .
- Install the rear wheels and tires.
- Tighten the wheel nuts to 140 Nm (103 lb.ft).
- Install fuse number 8 into the BJB.
NOTE:
Make sure that the brake cable circlip is positioned as shown.
CAUTION:
Make sure that the component is clean, free of foreign material and lubricant.
NOTE:
The adjustment procedure must be carried out in full.