LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Land Rover >> 2012 >> LR4 HSE Lux >> Repair and Diagnosis >> Steering >> Power Steering >> Power Steering >> Power Steering >> Removal And Installation >> Steering Gear - (5.0L) >> Installation

Steering Gear - (5.0L): Installation

  1. Clean the component mating faces.
  2. Install the steering gear.
    • Tighten the bolts to 175 Nm (129 lb.ft).
  3. Connect the electrical connector.
    4. NOTE: Do not install the support bracket bolt until the steering gear connections are tightened.
  4. Install the steering gear high pressure line.
    5. NOTE: Lubricate the seals with clean power steering fluid.
  5. Connect the steering gear pressure lines.
    • Clean the component mating faces.
    • Install new O-ring seals.
    • Tighten the bolt to 22 Nm (16 lb.ft).
  6. Install the power steering line support bracket.
    • Tighten the bolt to 10 Nm (7 lb.ft).
  7. Connect the tie-rod end ball joints.
    • Attach both tie rods to previously noted positions.
    • Tighten the tie-rod locking nut.
  8. Connect the universal joint to the steering gear.
    • Install a new patchlock bolt and tighten to 25 Nm (18 lb.ft).
  9. Install the radiator access panel.
    • Install the 4 bolts and tighten to 10 Nm (7 lb.ft).
  10. Install the front LH splash shield.
  11. Install the front RH splash shield.
  12. Fill and bleed the power steering system. Refer to Power Steering System Filling and Bleeding article.
  13. Adjust the front wheel alignment.
scientia non olet · About LEMON Manuals