LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Land Rover >> 2012 >> LR4 HSE Lux >> Repair and Diagnosis >> Steering >> Power Steering >> Power Steering >> Power Steering >> Removal And Installation >> Power Steering Pump - (VIN Range: 07 Model Year->Current) >> Removal

Power Steering Pump - (VIN Range: 07 Model Year->Current): Removal

  1. Disconnect the battery ground cable. Refer to Specifications article.
  2. Remove the engine cover. Refer to Engine Cover - 2.7L Diesel article.
  3. Remove the cooling fan shroud. Cooling Fan ShroudRefer to
  4. Recover the air conditioning (A/C) refrigerant. Refer to Air Conditioning (A/C) System Recovery, Evacuation and Charging article.
  5. Remove the auxiliary battery tray. Refer to Auxiliary Battery Tray article.
  6. Remove the accessory drive belt. Accessory Drive BeltRefer to
    7. WARNING: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.
  7. Raise and support the vehicle.
  8. Remove the LH front wheel and tire.
  9. Remove the fender splash shield lower trim panel.
    • Remove the 4 clips.
    GJ0011928
  10. Remove the front LH fender splash shield. Refer to Fender Splash Shield article.
  11. Remove the upper arm and brake line heat shields for access.
    • Remove the 3 nuts.
    • Remove the 3 bolts.
    GJ0019057
  12. Release the charge air cooler inlet pipe.
    • Remove the two retaining bolts.
    • Remove the retaining nut.
    GJ0019781
  13. Disconnect the charge air cooler inlet hose.
    • Loosen the clip.
    GJ0019782
  14. Disconnect the charge air cooler inlet hose.
    • Loosen the clip.
    GJ0019783
    15. CAUTION: Immediately cap all refrigerant lines to prevent ingress of dirt and moisture.
    CAUTION: Care must be taken to avoid damage to the mating surfaces.
  15. Release the A/C low pressure pipe from the compressor.
    • Remove and discard the O-ring seal.
    • Using a suitable tie strap, secure the A/C low-pressure pipe aside.
    GJ0019784
  16. Remove the power steering pump rear fixing bracket retaining bolt.
    • Reposition the charge air cooler inlet pipe to gain access to the power steering pump retaining bolt.
    GJ0019785
    17. WARNING: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.
  17. Lower the vehicle.
    18. CAUTION: If power steering fluid comes into contact with the paintwork, the affected area must be immediately washed down with cold water.
  18. Disconnect the high pressure line from the power steering gear.
    • Remove and discard the O-ring seal.
    • Install blanking caps to the exposed ports.
    • Allow the fluid to drain into a container.
    GJ0019786
    19. CAUTION: If power steering fluid comes into contact with the paintwork, the affected area must be immediately washed down with cold water.
  19. Disconnect the power steering pump supply hose.
    • Clamp the power steering pump supply hose to minimize fluid loss.
    • Install blanking caps to the exposed ports.
    GJ0019787
  20. Remove the power steering pump.
    • Remove the 3 power steering pump front retaining bolts.
    GJ0019788
scientia non olet · About LEMON Manuals