Defrost Vent/Register Blend Door Actuator - (LHD): Installation
- Install the defrost vent/register blend door actuator.
- Tighten the screws to 1 Nm.
- Connect the electrical connector.
- Install the passenger side footwell duct elbow.
- Tighten the screws.
- Install the passenger side footwell duct.
- Install the clip.
- Install the passenger side closing trim panel.
- Install the interior lamp.
- Connect the electrical connector.
- Secure the clip.
- Install the glove compartment. Refer to Glove Compartment article.