LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Land Rover >> 2012 >> LR4 HSE Lux >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> Engine >> Engine (V8 5.0L Petrol) >> General Procedures >> Engine Oil Vacuum Draining And Filling >> Draining

Engine Oil Vacuum Draining And Filling: Draining

WARNING: The spilling of hot engine oil is unavoidable during this procedure, care must be taken to prevent scalding.
CAUTION: Correct installation of the oil filler cap can be obtained by tightening the cap until hard stop.
NOTE: Make sure that the vehicle is parked on level ground.
NOTE: Clean the components general area prior to dismantling.
    • Start the engine and allow to run for 10 minutes, stop the engine.
    2. CAUTION: Allow 10 minutes from turning the engine off before starting oil extraction.
  2. See figure
    G00493383
  3. Refer to: ENGINE COVER
    • Loosen the element cover 4 complete turns to allow engine oil to drain from the filter cover.
      GJ0012839
    • Using the oil vacuum pump drain the oil out through the oil extraction tube.
      G00493385
    • Remove the oil vacuum pump.
  7. See Figure
    GJ0012840
    8. NOTE: Discard the O-ring seals.
  8. See figure
    GJ0012841
scientia non olet · About LEMON Manuals