LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Land Rover >> 2012 >> LR4 HSE Lux >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> Engine >> Engine (V8 5.0L Petrol) >> General Procedures >> Engine Oil Vacuum Draining And Filling >> Filling

Engine Oil Vacuum Draining And Filling: Filling

    NOTE: Install new O-ring seals.
  1. Lubricate the oil filter element O-ring seal with clean engine oil.
    GJ0012842
    2. CAUTION: Tighten the component finger tight first.
    • Torque: 25 Nm
      GJ0012843
    3. CAUTION: Make sure that the vehicle is left for 5 minutes from filling with oil and that the engine oil level is reading at least minimum (by following Steps 7-13), before starting the engine.
    • Fill the engine with oil - for filling values on vehicles without supercharger:

      Refer to: SPECIFICATIONS 

    • Fill the engine with oil - for filling values on vehicles with supercharger:

      Refer to: SPECIFICATIONS 

    • Clean any residual engine oil from the oil filler cap area.
  4. See Figure
    G00521034
    5. CAUTION: Make sure that the vehicle has been left for 5 minutes from filling with oil.
  5. Follow the Steps 7-13 before starting the engine.
    • Start the engine and allow to run for 10 minutes, stop the engine.
    • Check for leaks.
    7. CAUTION: Make sure that the selector lever and the gearshift mechanism are in the park (P) position.
    CAUTION: Make sure that the hood is open.
    • Turn the ignition on.
    • Press the right-hand directional button to access the instrument cluster menu.
      GJ0014458
    • Press the right-hand OK button.
      GJ0014459
    • Press the right-hand directional button to access the Oil Level Display.
      GJ0014460
    • Press the right-hand OK button and follow the instructions.
      GJ0014461
    • Press the cruise control cancel button twice within 2 seconds.
      GJ0014462
    • The message center display will revert to the normal display in the trip computer.
    • Press the right-hand OK button and follow the instructions.
    • Check that the oil level display shows an oil level reading.
    • Only after having started and run the engine for 10 minutes (as indicated in Step 6), switch off the engine, then stabilizing for 10 minutes, take a reading from the oil level display and, if necessary top up with engine oil.
      GJ0014463
    14. NOTE: If instructed to follow Steps 7-13 in a previous step, return to Step 6 and continue the procedure.
  14. Turn the ignition off.
  15. Allow 10 minutes for the engine oil level to stabilize if there has been additional oil top up.
    16. NOTE: The following steps are to update the average oil level value.
    GJ0014462
    • Turn the ignition on.
    • Press and hold the cruise control cancel button for more than 2 seconds.
    • The message center display will revert to the normal display in the trip computer.
  18. Turn the ignition off.
  19. Turn the ignition on.
    • Press the right-hand directional button to access the instrument cluster menu.
      GJ0014458
    • Press the right-hand OK button.
      GJ0014459
    • Press the right-hand directional button to access the Oil Level Display.
      GJ0014460
    • Press the right-hand OK button and follow the instructions.
    • Make sure that the average oil level value has now been updated.
      GJ0014463
  24. Refer to: ENGINE COVER
scientia non olet · About LEMON Manuals