Camshaft LH: Removal
CAUTION:
Make sure that the orientation and code on the top of the camshaft bearing caps is noted (along with the bank - A or B), so that on installation the components are installed to their original position. Failure to follow this instruction may cause damage to the vehicle.
NOTE:
Removal steps in this procedure may contain installation details.
NOTE:
Some variation in the illustrations may occur, but the essential information is always correct.
- Disconnect the battery ground cable. Refer to SPECIFICATIONS information.
- Raise and support the vehicle.
- Refer to: TIMING DRIVE COMPONENTS .
- See figure
WARNING:
Make sure to support the vehicle with axle stands.
CAUTION:
Rotate the camshafts until all the valves are at their minimum open point.
CAUTION:
Evenly and progressively, release the camshaft bearing caps.
NOTE:
Remove the camshaft bearing caps. Note: their position, orientation and markings. Each is marked with its position (number) and an orientation (arrow).
