LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Land Rover >> 2012 >> LR4 HSE Lux >> Repair and Diagnosis >> Engine Performance >> Fuel Delivery >> Fuel Charging And Controls >> Fuel Charging And Controls (V8 5.0L Petrol) >> Removal & Installation >> Fuel Rail RH >> Installation

Fuel Rail RH: Installation

    All vehicles 

  1. Install new O-ring seals.
    GJ0012977
  2. Install new Teflon seals.
    GJ0012978
  3. See figure
    GJ0012979
    4. CAUTION: If the original fuel injector is being installed, the original fuel injector clamp must installed with the fuel injector it was removed with.
  4. See figure
    GJ0012975
    5. CAUTION: If a new cylinder head has been installed then the special tool 310-200-02 without the thread must be used to install the fuel rail.
    NOTE: LH illustration shown, RH is similar.
  5. See figure
    GJ0012980
    6. CAUTION: Make sure that the area around the open fuel injector ports are clean and free of foreign material and lubricant prior to installing the fuel injector.
    CAUTION: When installing the fuel injector(s), make sure that the Teflon seal is clean and free of foreign material and lubricant.
    NOTE: LH illustration shown, RH is similar.
  6. See figure
    GJ0012981
    7. CAUTION: If new fuel injectors are installed, a new injector clamp must be installed.
    CAUTION: Make sure that the fuel injector is aligned and installed into the fuel rail correctly, as noted in the removal step.
    CAUTION: Tighten the fuel rail retaining bolts a turn at a time until the correct torque is achieved.
    NOTE: Lubricate the fuel injector O-ring seals with clean engine oil.
    NOTE: LH illustration shown, RH is similar.
  7. Torque: 20
    GJ0012982
    8. NOTE: LH illustration shown, RH is similar.
  8. See figure
    GJ0012983
    9. NOTE: LH illustration shown, RH is similar.
  9. Torque: 20
    GJ0012984
    10. NOTE: Tighten the bolts in the indicated sequence.
    NOTE: LH illustration shown, RH is similar.
  10. Torque:
    • Bolt 2 30 Nm
    • Bolt 3 30 Nm
    • Bolt 1 30 Nm
    • Bolt 4 30 Nm
      GJ0012985
  11. See figure
    GJ0012989
  12. Torque: 20
    GJ0012972
    13. NOTE: LH illustration shown, RH is similar.
  13. Torque: 7
    GJ0012971
    14. NOTE: LH illustration shown, RH is similar.
  14. See figure
    GJ0012986
    15. WARNING: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.
  15. Raise and support the vehicle.
    16. CAUTION: Lubricate only the union threads with clean engine oil.
    NOTE: Engine shown removed for clarity.
    NOTE: Install the bolt and unions finger tight before final tightening.
    NOTE: Remove and discard the blanking caps.
  16. See figure
    GJ0012991
  17. Lower the vehicle.
    18. NOTE: Do not tighten at this stage.
    NOTE: Remove and discard the blanking caps.
  18. See figure
    GJ0012992
    19. WARNING: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.
  19. Raise and support the vehicle.
    20. NOTE: Engine shown removed for clarity.
  20. Torque
    • Unions (1) 21 Nm
    • M6 (2) 11 Nm
    • M8 (3) 25 Nm
    • M5 nut (4) 6 Nm
      GJ0012873
    21. NOTE: Engine shown removed for clarity.
  21. Torque: 21
    GJ0012872
    22. NOTE: Engine shown removed for clarity.
  22. See figure
    GJ0012875
  23. Refer to Steering Gear - V8 5.0L Petrol information.
  24. Lower the vehicle.
  25. See figure
    GJ0012850
    26. CAUTION: Lubricate only the union threads with clean engine oil.
    NOTE: Do not tighten at this stage.
    NOTE: Remove and discard the blanking caps.
  26. See figure
    GJ0012819
  27. Torque:
    • Unions 21 Nm
    • Bolts 8 Nm
      GJ0012819
  28. Torque: 21
    GJ0012832
  29. Torque: 12
    GJ0012473
  30. See figure
    GJ0012471

    31. Right-hand drive vehicles 

  31. See figure
    GJ0012472
  32. Torque: 10
    GJ0012967

    33. Left-hand drive vehicles 

  33. Refer to Battery information.

    34. All vehicles 

  34. See figure
    GJ0012466
  35. See figure
    GJ0012558
  36. See figure
    GJ0012966
  37. Refer to Air Cleaner Outlet Pipe T-Connector information.
  38. Refer to Engine Cover - V8 5.0L Petrol information.
  39. Connect the battery ground cable. Refer to Specifications information.
scientia non olet · About LEMON Manuals