LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Land Rover >> 2012 >> LR4 HSE Lux >> Repair and Diagnosis >> Engine Performance >> Fuel Delivery >> Fuel Charging And Controls >> Fuel Charging And Controls (V8 5.0L Petrol) >> Removal & Installation >> Left-Hand Fuel Rail High-Pressure Fuel Pump >> Installation

Left-Hand Fuel Rail High-Pressure Fuel Pump: Installation

    NOTE: Lubricate the fuel rail high-pressure fuel pump bucket with clean engine oil.
  1. See figure
    GJ0012870
    2. CAUTION: Tighten the Torx screws a turn at a time until the correct torque is achieved.
    NOTE: Lubricate the fuel rail high-pressure fuel pump O-ring seal with clean engine oil.
  2. Torque: 11
    GJ0012859
  3. Loosen the Torx screws half a turn each.
    GJ0012859
  4. See figure
    GJ0012871
    5. CAUTION: Install new high-pressure fuel supply lines.
    CAUTION: Lubricate only the union threads with clean engine oil.
    NOTE: Remove and discard the blanking caps.
    NOTE: Engine shown removed for clarity.
    NOTE: Install the bolt and unions fully finger tight before final tightening.
  5. See figure
    GJ0012991
    6. CAUTION: Care must be taken when positioning the fuel rail high-pressure fuel pump cover to one side.
    NOTE: Fuel rail high-pressure fuel pump cover shown removed for clarity.
  6. Torque: 11
    GJ0012859
  7. Lower the vehicle.
    8. NOTE: Do not tighten at this stage.
    NOTE: Remove and discard the blanking caps.
    GJ0012992
  8. See figure
    9. WARNING: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.
  9. Raise and support the vehicle.
    10. NOTE: Engine shown removed for clarity.
  10. Torque
    • Unions (1) 21 Nm
    • M6 (2) 11 Nm
    • M8 (3) 25 Nm
    • M5 nut (4) 6 Nm
    GJ0012873
    11. NOTE: Engine shown removed for clarity.
  11. Torque: 21
    GJ0012872
    12. NOTE: Install the bolt and unions finger tight before final tightening.
    NOTE: Remove and discard the blanking caps.
  12. Torque
    • Unions 21 Nm
    • M6 11 Nm
      GJ0012995
  13. Torque: 21
    GJ0012996
    14. NOTE: Engine shown removed for clarity.
  14. Torque:
    • M10 29 Nm
    • M6 11 Nm
      GJ0012994
    15. NOTE: Engine shown removed for clarity.
  15. See figure
    GJ0012875
  16. Torque: 25
    GJ0012137
  17. Refer to Generator information.
  18. Refer to Engine Mount RH information.
  19. Refer to Steering Gear - 5.0L information.
  20. Lower the vehicle.
  21. See figure
    GJ0012850
    22. NOTE: Lubricate the union threads with clean engine oil.
    NOTE: Do not tighten at this stage.
    NOTE: Remove and discard the blanking caps.
  22. See figure
    GJ0012819
  23. Torque:
    • Unions 21 Nm
    • Bolts 8 Nm
      GJ0012819
  24. Torque: 21
    GJ0012832
  25. Refer to Air Cleaner Outlet Pipe T-Connector information.
  26. See figure
    GJ0012993
  27. See figure
    GJ0012528
  28. Refer to Engine Oil Draining and Filling information.
  29. Connect the battery ground cable. Refer to Specifications information.
scientia non olet · About LEMON Manuals