Pinpoint Test E: Roof Opening Panel - Bounce Back

E1: INITIALIZATION

NOTE: These tests are to be carried out to determine the cause of the unnecessary roof opening panel bounce back

Perform the manual roof opening panel initialization procedure REFER to: Power Roof Opening Panel Initialization . Check for correct roof opening panel operation
Operate the roof opening panel through all possible positions (slide open / slide close / tilt open / tilt close) using the roof mounted switch
3 Operate the roof opening panel one touch function five times in succession using the roof mounted switch

Does the roof opening panel operate correctly five times in succession?

Yes:

No further action required

No:

GO to E2 .

E2: GUIDES - INSPECTION

NOTE: Image shows glass panel removed for clarity. Do not remove the glass panel at this time

Carry out visual inspection of the guides

Are the guides free from debris and obstruction?

Yes:

GO to E3 .

No:

Remove any debris or obstruction. Check for correct operation. (1) If correct no further action required. (2) If customer concern is still evident GO to E3 .

E3: SIDE COVERS

Carry out visual inspection of the side covers attached to the glass panel

Are the side covers bent or damaged?

Yes:

Replace the glass panel REFER to: Roof Opening Panel Glass . Check for correct operation. (1) If correct no further action required. (2) If customer concern is still evident GO to E4 .

No:

GO to E4 .

E4: WIND DEFLECTOR

Carry out visual inspection of the wind deflector

Is the wind deflector damaged or incorrectly located?

Yes:

Re-install or replace the wind deflector as required. Check for correct operation. Check for correct operation. (1) If correct no further action required. (2) If customer concern is still evident contact dealer technical support

No:

If concern still evident contact dealer technical support