LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Land Rover >> 2012 >> LR4 HSE Lux >> Repair and Diagnosis >> Accessories & Equipment >> Wiring System (Data Link Connectors, Pwr Dist., Grnd Dist.) >> Wiring Harnesses >> Wiring Harnesses >> Removal And Installation >> Front Parking Aid Camera Wiring Harness - Front Section (LHD AWD) >> Removal

Front Parking Aid Camera Wiring Harness - Front Section (LHD AWD): Removal

CAUTION: Make sure that the camera overlay wiring harness is not bent excessively during this procedure. Failure to follow this instruction may result in damage to the harness.
  1. Remove the central junction box (CJB). Refer to: Central Junction Box (CJB) information.
    2. NOTE: RHD shown, LHD similar.
    NOTE: The left hand front camera wiring harness connectors are coloured magenta, the right hand front camera wiring harness connectors are coloured blue.
  2. Disconnect the electrical connector.
    GJ0014324
  3. Remove the battery. Refer to: Battery information.
  4. Remove the battery compartment side wall.
    • Release the battery positive cable and grommet.
    • Release the 4 clips.
    GJ0014325
    5. NOTE: RHD shown, LHD similar.
  5. Release the engine compartment fuse box.
    • Remove the bolt.
    GJ0014326
  6. Remove the air cleaner.
    7. NOTE: The left hand front camera wiring harness connectors are coloured white, the right hand front camera wiring harness connectors are coloured green.
  7. Disconnect the electrical connector.
    GJ0014331
scientia non olet · About LEMON Manuals