LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Land Rover >> 2012 >> LR4 HSE Lux >> Repair and Diagnosis >> Accessories & Equipment >> Wiring System (Data Link Connectors, Pwr Dist., Grnd Dist.) >> Wiring Harnesses >> Wiring Harnesses >> Removal And Installation >> Left Hand Parking Aid Camera Wiring Harness >> Installation

Left Hand Parking Aid Camera Wiring Harness: Installation

    CAUTION: Make sure that the camera overlay wiring harness is not bent excessively during this procedure. Failure to follow this instruction may result in damage to the harness.
  1. Install the camera overlay wiring harness.
    GJ0014332
  2. Connect the electrical connector.
    GJ0014350
  3. Install the wiring harness cover.
    • Secure the 4 clips.
    GJ0014347
  4. Install the gaiter.
    GJ0014351
  5. Secure the bracket.
    • Secure the 6 clips.
    GJ0014352
    6. CAUTION: Make sure that any tie straps used are not tightened excessively on the camera wiring harness and link leads, Failure to follow this instruction may result in damage to the harness.
  6. Feed the camera overlay wiring harness along the main wiring harness to the parking aid camera module.
    • Using suitable tie straps, secure the camera overlay wiring harness to the main body wiring harness.
  7. Connect the electrical connector.
    GJ0014362
  8. Install the wiring harness cover.
    • Secure the 3 clips.
    GJ0014341
  9. Install the LH scuff plate trim panel. Refer to: Scuff Plate Trim Panel information.
  10. Install the LH front seat. Refer to: Front Seat information.
  11. Install the cowl side trim panel. Refer to: Cowl Side Trim Panel information.
  12. Install the closing trim panel.
    • Connect the electrical connector.
    • Secure the clip.
    • Tighten the screws.
    GJ0013955
scientia non olet · About LEMON Manuals