LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Land Rover >> 2012 >> LR4 HSE Lux >> Repair and Diagnosis >> Accessories & Equipment >> Wiring System (Data Link Connectors, Pwr Dist., Grnd Dist.) >> Wiring Harnesses >> Wiring Harnesses >> Removal And Installation >> Right Hand Parking Aid Camera Wiring Harness >> Installation

Right Hand Parking Aid Camera Wiring Harness: Installation

    CAUTION: Make sure that the camera overlay wiring harness is not bent excessively during this procedure. Failure to follow this instruction may result in damage to the harness.
  1. Install the camera overlay wiring harness
    GJ0014332
    2. CAUTION: Make sure that excessive force is not used when installing the tie straps to the wiring harness. Failure to follow this instruction may result in damage to the vehicle.
  2. Carefully feed the camera overlay wiring harness along the main body wiring harness from the camera module to the RH A-pillar.
    • Using suitable tie straps, secure the camera overlay wiring harness to the main body wiring harness.
    3. NOTE: Left-hand shown, right-hand similar.
  3. Connect the electrical connector.
    GJ0014350
    4. NOTE: Left-hand shown, right-hand similar.
  4. Install the wiring harness cover.
    • Secure the 4 clips.
    GJ0014347
    5. NOTE: Left-hand shown, right-hand similar.
  5. Install the gaiter.
    GJ0014351
    6. NOTE: Left-hand shown, right-hand similar.
  6. Secure the bracket.
    • Secure the 6 clips.
    GJ0014352
  7. Install the dynamic response module.
    • Connect the 2 electrical connecotrs.
    • Tighten the 2 bolts.
    GJ0014342
  8. Secure the wiring harness cover.
    • Secure the 12 clips.
    • Re-apply suitable tape to the wiring harness cover in the positions previously secured.
    • Install the floor covering.
    GJ0014345
  9. Connect the 2 electrical connectors.
    • Secure the 3 clips.
    GJ0014343
  10. Connect the 2 electrical connectors.
    • Secure the clip.
    GJ0014344
  11. Connect the electrical connector.
    GJ0014349
  12. Install the accelerator pedal assembly. information.
  13. Install the RH cowl side trim panel. Refer to: Cowl Side Trim Panel information.
  14. Install the LH wiring harness cover.
    • Secure the 3 clips.
    GJ0014341
  15. Repeat procedure for the other side.
  16. Install the LH scuff plate trim panel. Refer to: Scuff Plate Trim Panel information.
  17. Repeat procedure for the other side.
  18. Install the floor console. Refer to: Floor Console information.
  19. Install the LH front seat. Refer to: Front Seat information.
  20. Repeat procedure for the other side.
scientia non olet · About LEMON Manuals