Windshield Glass: Removal
CAUTION:
Always protect paintwork and glass when removing exterior components.
CAUTION:
Always protect the interior components when removing body glass.
CAUTION:
Lay the glass on felt covered supports. Do not stand on edge as this can cause chips which subsequently develop into cracks.
NOTE:
The following equipment is required: l Cutting wire and handles l Kent knife l Glazing knife l Windshield replacement kit l Sealant applicator gun l Suction cups l A felt covered table or stand to support glass
- Remove the plenum chamber panel. Refer to Plenum Chamber .
- Remove both A-pillar upper trim panels. Refer to A-Pillar Trim Panel .
- Remove the rain sensor. Refer to Rain Sensor .
- Remove the roof moulding.
- Release the 6 clips.
- Repeat the above procedure for the other side.
- With assistance, remove the windshield glass.
- If installed, disconnect the 4 electrical connectors.
- Carefully cut through the sealant using a glazing knife or cutting wire.
- Attach the suction cups.
- Noting fitted position, remove the 4 spacers.
WARNING:
Eye protection must be worn.
