Instrument Cluster: Installation
- Install the instrument cluster.
- Connect the electrical connector.
- Tighten the screws.
- Install the instrument cluster trim panel.
- Secure the 2 clips.
- Secure the 2 tangs.
- Install the steering column gaiter panel.
- Secure with the clips.
- Tighten the Torx screws.
- Install the steering column switch assembly.
- Tighten the Torx bolts to 3 Nm (2 lb.ft).
- Connect the clockspring and multifunction switch electrical connectors.
- Install the steering column side trim panel.
- Secure with the clip.
- Connect the electrical connector.
- Install the audio unit control trim panel.
- Install the 2 retaining screws.
- Install the steering column shrouds.
- Tighten the Torx screws.
- Install the instrument panel access panel.
- Secure with the clips.
- Install the headlamp switch trim panel. Refer to Driver Side Register Trim Panel article.
- Install the steering wheel.
- Connect the battery ground cable. Refer to Specifications article.
- Using the diagnostic tool, configure the instrument cluster.
CAUTION:
When installing the lower locating tang of the trim panel, make sure the floor console is not damaged. If necessary protect the surrounding areas using masking tape.
NOTE:
To install, reverse the removal sequence.
NOTE:
Make sure that all the clips are correctly installed.