LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Land Rover >> 2012 >> LR4 HSE Lux >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Warning Systems >> Warning Devices >> Warning Devices >> Removal And Installation >> Low Tire Pressure Module >> Removal

Low Tire Pressure Module: Removal

NOTE: If the tire pressure module is to be replaced then T4 must be connected and the correct procedures adhered to, prior to battery disconnection.
  1. Disconnect the battery ground cable. Refer to Specifications article.
  2. Remove the LH A-pillar upper trim panel. Refer to A-Pillar Trim Panel article.
  3. Remove the LH B-pillar upper trim panel. Refer to B-Pillar Upper Trim Panel article.
  4. Remove the LH C-pillar upper trim panel. Refer to C-Pillar Upper Trim Panel article.
  5. Remove the LH sun visor.
    • Remove the cover.
    • Remove the 2 screws.
    • Disconnect the electrical connector.
    GJ0018492
  6. Remove the sun visor retaining clip.
    • Release the screw cover.
    • Remove the screw.
    GJ0014795
  7. Remove the LH passenger assist handles.
    • Carefully release the 6 screw covers.
    • Remove the 6 screws.
    GJ0014600
  8. Release the LH side of the headliner.
    • Release the 6 clips.
    GJ0018493
  9. Remove the low tire pressure module.
    • Disconnect the 2 electrical connectors.
    • Remove the 2 bolts.
    GJ0018494
scientia non olet · About LEMON Manuals