Liftgate Window Glass: Removal
CAUTION:
Always protect paintwork and glass when removing exterior components.
CAUTION:
Always protect the interior components when removing body glass.
CAUTION:
Lay the glass on felt covered supports. Do not stand on edge as this can cause chips which subsequently develop into cracks.
NOTE:
The following equipment is required: l Cutting wire and handles l Kent knife l Glazing knife l Glass replacement kit l Sealant applicator gun l Suction cups l A felt covered table or stand to support glass
- Remove the rear wiper arm. Refer to Rear Wiper Pivot Arm .
- Remove the rear wiper drive spindle seal.
- Remove the liftgate lower trim panel. Refer to Liftgate Trim Panel
.
- Remove the liftgate upper trim panel.
- Release the 4 clips.
- Remove the liftgate side trim panel.
- Release the 4 clips.
- Repeat the above procedure for the other side.
- Disconnect both heated rear window electrical connectors.
- With assistance, remove the liftgate window glass.
- Carefully cut through the sealant using a glazing knife or cutting wire.
- Attach the suction cups.
- Noting fitted position, remove the 5 spacers.
WARNING:
Eye protection must be worn.
