Windshield Wiper Motor: Installation
- Install the wiper linkage.
- Tighten the bolts to 10 Nm (7 lb.ft).
- Tighten the nut to 25 Nm (18 lb.ft).
- Install the windshield wiper motor and linkage.
- Tighten the bolts to 6 Nm (4 lb.ft).
- Connect the electrical connector.
- Install the clips.
- Install the plenum chamber panel. Refer to Plenum Chamber .
CAUTION:
Make sure the windshield wiper motor is located on its stud prior to installing the bolts.