LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Land Rover >> 2012 >> LR4 HSE Lux >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Wiring System (Data Link Connectors, Pwr Dist., Grnd Dist.) >> Wiring Harnesses >> Wiring Harnesses >> Removal And Installation >> Engine Wiring Harness (4.0L) >> Installation

Engine Wiring Harness (4.0L): Installation

    NOTE: Align to the position noted on removal.
  1. Install the engine wiring harness.
  2. Connect the CKP sensor electrical connector.
  3. Connect the HO2S electrical connectors.
  4. Install the electrical harness bridge.
    • Tighten the bolts to 45 Nm (33 lb.ft).
  5. Connect the breather electrical connector.
  6. Connect the PCV electrical connector.
  7. Connect the CMP sensor electrical connector.
    • Secure the clip.
  8. Connect the cooling fan electrical connector.
    • Carefully secure the clips.
  9. Connect the KS electrical connectors.
  10. Connect the generator.
  11. Connect the ECT sensor electrical connector.
  12. Connect the MAF sensor electrical connector.
    • Secure the clip.
  13. Connect the fuel injector electrical connectors.
    • Carefully secure the clips.
  14. Connect the engine wiring harness.
    • Install the clips on the harness protective cover.
    • Connect and secure the electrical connectors.
  15. Install the battery compartment side wall.
    • Secure the clips.
    • Install the battery positive cable and grommet.
  16. Install the engine compartment upper heat shield.
    • Secure the clips.
    • Tighten the screw.
  17. Install the fusebox main feed cable.
    • Install the bolt and tighten to 10 Nm (7 lb.ft).
  18. Install the battery. Refer to: Battery information.
  19. Install the intake manifold. information.
  20. Install the engine undershield. Refer to: Engine Undershield information.
  21. Connect the battery ground cable. Refer to: Specifications information.
scientia non olet · About LEMON Manuals