LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Land Rover >> 2012 >> LR4 HSE Lux >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Wiring System (Data Link Connectors, Pwr Dist., Grnd Dist.) >> Wiring Harnesses >> Wiring Harnesses >> Removal And Installation >> Front Parking Aid Camera Wiring Harness - Front Section (RHD AWD) >> Installation

Front Parking Aid Camera Wiring Harness - Front Section (RHD AWD): Installation

    CAUTION: Make sure that the camera overlay wiring harness is not bent excessively during this procedure. Failure to follow this instruction may result in damage to the harness.
  1. Install the camera overlay wiring harness
    GJ0014332
    2. NOTE: Some variation in the illustrations may occur, but the essential information is always correct.
  2. Remove the connector from the camera overlay wiring harness.
    • Remove the locking tab.
    • Carefully release the clip.
    • Apply suitable tape to protect the end of the camera overlay wiring harness.
      GJ0014333
  3. Using suitable tape, secure a suitable rod to the camera overlay wiring harness.
    GJ0014334
  4. Carefully feed the camera overlay wiring harness under the bracket.
    GJ0014335
  5. Carefully feed the camera overlay wiring harness through the wiring harness carrier.
    GJ0014336
  6. Carefully feed the camera overlay wiring harness through the wiring harness carrier.
    GJ0014337
  7. Using a suitable tool, make a hole in grommet in the position shown.
    GJ0014338
  8. With the aid of another technician, carefully feed the camera overlay wiring harness through the grommet.
    GJ0014339
    9. NOTE: Some variation in the illustrations may occur, but the essential information is always correct.
  9. Install the connector to the camera overlay wiring harness.
    • Remove the protective tape.
    • Install the electrical connector.
    • Secure the locking tab.
      GJ0014340
    10. NOTE: The left hand front camera wiring harness connectors are coloured magenta, the right hand front camera wiring harness connectors are coloured blue.
  10. Connect the electrical connector.
    GJ0014324
    11. NOTE: The left hand front camera wiring harness connectors are coloured white, the right hand front camera wiring harness connectors are coloured green.
  11. Connect the electrical connector.
    GJ0014331
    12. CAUTION: Make sure that excessive force is not used when installing the tie straps to the wiring harness. Failure to follow this instruction may result in damage to the harness.
  12. Using suitable tie straps, secure the camera overlay wiring harness to the main body wiring harness.
  13. Secure the 3 clips.
    GJ0014330
  14. Secure the wiring harness carrier.
    • Tighten the 4 nuts.
      GJ0014329
  15. Secure the engine compartment fuse box.
    • Tighten the bolt.
      GJ0014326
  16. Install the battery compartment side wall.
    • Secure the 4 clips.
    • Install the battery positive cable and grommet.
      GJ0014325
  17. Install the air cleaner.
  18. Install the brake master cylinder cover.
    GJ0014327
  19. Secure the hood seal.
  20. Install the CJB. Refer to: Central Junction Box (CJB) information.
  21. Install the battery. Refer to: Battery information.
scientia non olet · About LEMON Manuals