Rear Parking Aid Camera Wiring Harness: Installation
- Install the camera overlay wiring harness
- Feed the camera overlay wiring harness along the main wiring harness to the parking aid camera module.
- Using suitable tie straps, secure the camera overlay wiring harness to the main body wiring harness.
- Connect the electrical connector.
- Install the LH D-pillar upper trim panel. Refer to: D-Pillar Trim Panel information.
- Install the rear headliner trim panel.
- Connect the electrical connector.
- Secure the wiring harness cover.
- Install the LH scuff plate trim panel. Refer to: Scuff Plate Trim Panel information.
- Install the LH front seat. Refer to: Front Seat information.
CAUTION:
Make sure that the camera overlay wiring harness is not bent excessively during this procedure. Failure to follow this instruction may result in damage to the harness.
CAUTION:
Make sure that excessive force is not used when installing the tie straps to the wiring harness. Failure to follow this instruction may result in damage to the harness.
