Rear Parking Aid Camera Wiring Harness - Liftgate Section: Installation
- Install the camera overlay wiring harness.
- Remove the electrical connector from the camera overlay wiring harness.
- Align the camera wiring harness tang with the electrical connector clip.
- Carefully release the clip.
- Apply suitable tape to protect the end of the camera overlay wiring harness.
- Using suitable tape, secure a suitable rod to the camera overlay wiring harness.
- Carefully feed the camera overlay wiring harness though the conduit.
- Install the connector to the camera overlay wiring harness.
- Connect the electrical connector.
- Using suitable tie straps, secure the camera overlay wiring harness to the tailgate harness.
- Connect the electrical connector.
- Secure the liftgate conduit.
- Install the liftgate side trim panel.
- Secure the 5 clips.
- Install the liftgate upper trim panel.
- Secure the 4 clips.
- Install the liftgate lower trim panel. Refer to: Liftgate Trim Panel information.
- Install the rear headliner trim panel.
- Connect the electrical connector.
- Secure the 7 clips.
CAUTION:
Make sure that the camera overlay wiring harness is not bent excessively during this procedure. Failure to follow this instruction may result in damage to the harness.
NOTE:
Some variation in the illustrations may occur, but the essential information is always correct.
NOTE:
Some variation in the illustrations may occur, but the essential information is always correct.
CAUTION:
Make sure that excessive force is not used when installing the tie straps to the wiring harness. Failure to follow this instruction may result in damage to the vehicle.
