LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Land Rover >> 2012 >> LR4 HSE Lux >> Repair and Diagnosis (Single Page) >> Body & Frame >> Door Locks >> Anti-Theft - Passive >> Anti-Theft - Passive >> Removal And Installation >> Passive Anti-Theft System (Pats) Module >> Removal

Passive Anti-Theft System (Pats) Module: Removal

NOTE: If the PATS module is to be replaced then T4 must be connected and the correct procedures adhered to, prior to the battery disconnection.
  1. Disconnect the battery ground cable. Refer to Specifications information.
  2. Remove the RH A-pillar upper trim panel. Refer to A-Pillar Trim Panel information.
  3. Remove the RH B-pillar upper trim panel. Refer to B-Pillar Upper Trim Panel information.
  4. Remove the RH C-pillar upper trim panel. Refer to C-Pillar Upper Trim Panel information.
  5. Remove the RH sun visor.
    • Remove the screw covers.
    • Remove the 2 screws.
      GJ0018492
  6. Remove the sun visor retaining clip.
    • Release the screw cover.
    • Remove the screw.
      GJ0014795
  7. Remove the RH passenger assist handles.
    • Carefully release the 4 screw covers.
    • Remove the 4 screws.
      GJ0014600
  8. Remove the rear headliner trim panel.
    • Release the 7 clips.
      GJ0014599
  9. Release the RH side of the headliner.
    • Carefully release the 4 clips.
      GJ0019384
  10. Remove the PATS module.
    • Disconnect the electrical connector.
    • Remove the 2 bolts.
      GJ0015016
scientia non olet · About LEMON Manuals