LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Land Rover >> 2012 >> LR4 HSE Lux >> Repair and Diagnosis (Single Page) >> Body & Frame >> Door Locks >> Handles, Locks, Latches & Entry Systems >> Handles, Locks, Latches And Entry Systems >> Removal And Installation >> Ignition Lock Cylinder >> Removal

Ignition Lock Cylinder: Removal

NOTE: This procedure is for removal and installation of the ignition lock cylinder. The ignition lock and door lock cylinders are replaced in sets.
  1. Fully extend the steering column for access.
  2. Remove the steering column upper shroud.
    • Release the 4 clips.
    GJ0016989
  3. Remove the steering column lower shroud.
    • Remove the 3 Torx screws.
    • Release the steering column adjustment lever.
    GJ0016990
  4. Remove the passive coil.
    • Disconnect the electrical connector.
    • Release the 2 clips.
  5. Remove the ignition lock cylinder.
    • Turn the ignition key to position 1.
    • Insert a pin, not exceeding 2 mm diameter, through the access hole in the ignition lock cylinder housing to depress the plunger, and release the ignition lock cylinder.
    GJ0015943
scientia non olet · About LEMON Manuals