B-Pillar Upper Trim Panel: Removal
- Make the SRS system safe. Refer to Standard Workshop Practices article.
- Remove the B-pillar lower trim panel. See B-Pillar Lower Trim Panel .
- Release the safety belt lower anchor from the seat.
- Remove the bolt cover.
- Passenger side, disconnect the electrical connector.
- Remove the Torx bolt.
- Remove the B-pillar upper trim panel.
- Release the front and rear door weatherstrips for access.
- Release the 2 lower clips, then the remaining upper clip.
- Release the safety belt.
NOTE:
Make sure the seat belt height adjuster is at its lowest point prior to removal of the B-pillar upper trim panel.
