Transmission Support CROSSMEMBER (V6 4.0L Petrol/TDV6 2.7L Diesel): Installation
- Install the crossmember.
- Tighten the nuts and bolts to 90 Nm (66 lb.ft).
- Install the transmission support insulator through-bolt and tighten to 175 Nm (129 lb.ft).
- Attach the HO2S wiring harness and bracket to the crossmember.
- Tighten the bolts to 10 Nm (7 lb.ft).
- Secure the 3 fuel lines.
- Secure in the clips.
- Connect the exhaust front mounting.
- Install the transmission undershield.
- Tighten the bolts to 10 Nm (7 lb.ft).
All vehicles
Vehicles with petrol engine
CAUTION:
Make sure the H02S wiring harness is not twisted more than 180 degrees and is not in contact with either the exhaust or driveshaft.
Vehicles with diesel engine
All vehicles