LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Land Rover >> 2012 >> LR4 HSE Lux >> Repair and Diagnosis (Single Page) >> Body & Frame >> Sun Roof/T-Top/Convertible Top >> Roof Opening Panel >> Roof Opening Panel >> Removal And Installation >> Roof Opening Panel Blind >> Installation

Roof Opening Panel Blind: Installation

    NOTE:

    This step must be followed if the roof opening panel blind tension has been lost. 

    • Rewind the roof opening panel. 
      • CAUTION:

      Make sure that all tension is removed from the roof opening panel blind. Push the spring axle 3-4 times until all tension is removed, then follow the steps below. 

    • 1. Push the spring axle into the roof opening panel blind.
    • 2. Using a suitable tool, hold and rotate the spring axle 13 turns (360°).
      • NOTE: This step is to lock the tension to the roof opening panel blind prior to installation.
    • 3. Pull the spring axle 17 mm from the roof opening panel blind once the 13 rotations have been completed.
    G00523444
    • Install the roof opening panel blind sliders to the runners. 
    • 1. Push the roof opening panel blind right slider in to the runner.
    • 2. Install the left slider clockwise to the runner.
    GJ0021725
    3. CAUTION: Make sure that the roof opening panel blind tension remains during installation.
    • Install the roof opening panel blind to the mounting brackets. 
    • Carefully locate the roof opening panel blind tube to the left-hand mounting bracket.
    • Using a suitable tool, push the roof opening panel blind locking tang inwards of the blind and install the blind to the mounting bracket (as illustrated).
    G00523436
  4. Close the roof opening panel blind.
    GJ0021719
    5. CAUTION:

    Make sure that the spring axle is correctly located into the roof opening panel. 

    • Open the roof opening panel blind and check for correct operation.
  6. Install the headliner.
  7. Install the passenger assist handle.
    8. NOTE: Repeat the procedure for both sides.
  8. Install the sun visor retaining clip.
    9. NOTE: Repeat the procedure for both sides.
  9. Install the sun visor.
  10. Install the overhead console.
    11. NOTE: Repeat the procedure for both sides.
  11. Refer to: D-PILLAR TRIM PANEL .
    12. NOTE: Repeat the procedure for both sides.
  12. Refer to: C-PILLAR UPPER TRIM PANEL .
    13. NOTE: Repeat the procedure for both sides.
  13. Refer to: B-PILLAR UPPER TRIM PANEL .
    14. NOTE: Repeat the procedure for both sides.
  14. Refer to: A-PILLAR TRIM PANEL .
scientia non olet · About LEMON Manuals