Roof Opening Panel Motor: Installation

Install the roof opening panel motor.
- Install the spacer.
- Tighten the Torx screws to 4 Nm (3 lb.ft).
- Connect the electrical connector.
Position the headliner.
- Secure with the clips.
Install the passenger assist handles.
- Install the screws.
- Secure the screw covers.
Install the sun visors.
- Install the clips.
- Install the screws.
- Install the screw covers.
- Connect the electrical connectors.
Install the front overhead console.
- Connect the electrical connector.
- Carefully secure the clips.
Install both B-pillar upper trim panels. Refer to B-Pillar Upper Trim Panel article.
Install both A-pillar upper trim panels. Refer to A-Pillar Trim Panel article.
Using T4, configure a new roof opening panel motor.
If the battery has been disconnected, the one touch and anti-trap function will become inoperative. Close the roof opening panel and continue to hold the switch for a further 20 seconds to allow the sunroof to complete a full cycle. This will complete the roof opening panel calibration routine and reset these functions.