Brake Disc - (Vehicles With: Standard Brakes): Installation
- Make sure the brake disc and hub mating surfaces are clean.
- Install the brake disc.
- Tighten the Torx screw to 35 Nm (26 lb.ft).
- Install the brake caliper and anchor plate.
- Clean the component mating faces.
- Tighten the bolts to 275 Nm (203 lb.ft).
- Install the wheel and tire.
- Depress the brake pedal several times, check the fluid level in the brake fluid reservoir and top-up with brake fluid if necessary.
- Refer to Brake Pad Bedding-In information.
NOTE:
Tighten the wheel nuts in the sequence shown:
