LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Land Rover >> 2012 >> LR4 HSE Lux >> Repair and Diagnosis (Single Page) >> Brakes >> Mechanical - Hydraulic >> Front Disc Brake >> Front Disc Brake >> Removal And Installation >> Brake Caliper - (Vehicles With: Standard Brakes) >> Removal

Brake Caliper - (Vehicles With: Standard Brakes): Removal

CAUTION: LH illustration shown, RH is similar.
NOTE: Removal steps in this procedure may contain installation details.
NOTE: Some variation in the illustrations may occur, but the essential information is always correct.
    WARNING: Make sure to support the vehicle with axle stands.
  1. Raise and support the vehicle.
  2. Remove the wheel and tire.
    3. CAUTION: The brake pad wear indicator sensor is easily damaged. Do not use a lever to remove the sensor. Use fingers only.
  3. LH side only: Disconnect the brake pad wear indicator sensor.
    GJ0013158
    4. WARNING: Be prepared to collect escaping fluid.
    CAUTION: Before disconnecting or removing components, ensure the area around the joint faces and connections are clean. Plug open connections to prevent contamination.
  4. Disconnect the brake hose from the brake caliper.
    • Remove the union.
    • Remove and discard the two sealing washers.
    • Install blanking caps to the exposed ports.
      GJ0013159
    5. NOTE: Note the orientation of the brake pads.
  5. Remove the brake pads. Refer to: Brake Pads - Vehicles With: Standard Brakes .
    6. NOTE: Use an additional wrench to prevent the component from rotating.
  6. Remove the brake caliper housing.
    • Remove the brake caliper upper bolt.
      GJ0013160
scientia non olet · About LEMON Manuals