LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Land Rover >> 2012 >> LR4 HSE Lux >> Repair and Diagnosis (Single Page) >> Brakes >> Mechanical - Hydraulic >> Rear Disc Brake >> Rear Disc Brake >> Removal And Installation >> Brake Pads >> Removal

Brake Pads: Removal

WARNING: Brake pads must be renewed in axle sets only, otherwise braking efficiency may be impaired.
NOTE: RH illustration shown, LH is similar.
NOTE: The brake pad wear warning indicator sensor must be replaced each time the brake pads are serviced.
    WARNING: Make sure to support the vehicle with axle stands.
  1. Raise and support the vehicle.
  2. Remove the wheels and tires.
  3. RH side rear: Disconnect the brake pad wear indicator sensor wiring harness.
    GJ0013167
  4. RH side rear: Disconnect the brake pad wear indicator sensor wiring harness.
    GJ0013168
  5. RH side rear: Release and disconnect the brake pad wear indicator wiring harness electrical connector.
    GJ0013169
    6. NOTE: Use an additional wrench to prevent the component from rotating.
  6. Remove the brake caliper lower bolt.
    GJ0013170
    7. NOTE: Note the orientation of the brake pads.
    NOTE: Note the orientation of the clips.
  7. Remove the brake pads.
    • Rotate the brake caliper upwards.
    • Remove the 2 clips.
    GJ0013171
  8. Repeat the above 2 steps for the other side.
scientia non olet · About LEMON Manuals