LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Land Rover >> 2012 >> LR4 HSE Lux >> Repair and Diagnosis (Single Page) >> Brakes >> Mechanical - Hydraulic >> Rear Disc Brake >> Rear Disc Brake >> Removal And Installation >> Brake Caliper >> Installation

Brake Caliper: Installation

    NOTE: Use an additional wrench to prevent the component from rotating.
  1. Install the brake caliper.
    • Tighten the brake caliper upper bolt to 35 Nm (26 lb.ft).
    2. NOTE: Make sure the brake pads are installed in the correct orientation.
  2. Install the brake pads. See Brake Pads .
  3. Connect the brake hose to the brake caliper.
    • Clean the component mating faces.
    • Remove the blanking caps from the ports.
    • Install new sealing washers.
    • Tighten the brake hose union to 32 Nm (24 lb.ft).
  4. Connect the brake pad wear indicator sensor.
  5. Bleed the brake caliper. Refer to Component Bleeding - Vehicles With: Standard Brakes article.
  6. Install the wheel and tire.
    • Tighten the wheel nuts to 140 Nm (103 lb.ft).
scientia non olet · About LEMON Manuals