Brake Caliper Anchor Plate: Removal
NOTE:
RH illustration shown, LH is similar.
- Raise and support the vehicle.
- Remove the wheel and tire.
- RH side only: Disconnect the brake pad wear indicator sensor.
- Release from the clip.
- Remove the rear brake pads. See Brake Pads .
- Remove the brake caliper housing.
- Remove the brake caliper upper bolt.
- Remove the brake caliper anchor plate.
- Remove the guide pins and seals.
WARNING:
Make sure to support the vehicle with axle stands.
CAUTION:
The brake pad wear indicator sensor is easily damaged. Do not use a lever to remove the sensor. Use fingers only.
NOTE:
Use an additional wrench to prevent the component from rotating.
NOTE:
Note the orientation of the brake caliper guide pins.
