Front Driveshaft (4.0L): Installation
- Install the driveshaft.
- Clean the components.
- Compress the joints to engage the drive flanges.
- Attach the driveshaft to the front axle drive flange.
- Tighten the new Torx bolts to 45 Nm (33 lb.ft), then a further 90 degrees.
- Attach the driveshaft to the transfer case drive flange.
- Tighten the new Torx bolts to 45 Nm (33 lb.ft), then a further 90 degrees.
- Install the exhaust system.
- Connect the battery ground cable. Refer to Specifications information.
NOTE:
A small amount of oil may weep from the driveshaft joints during storage. The loss of this oil will not affect the operation or durabilty of the joint.