Coolant Pump: Removal
NOTE:
Removal steps in this procedure may contain installation details.
- Disconnect the battery ground cable. Refer to Specifications .
- Raise and support the vehicle.
- Cooling System Draining, Filling and Bleeding. Refer to: COOLING SYSTEM DRAINING, FILLING AND BLEEDING .
- See figure
- Refer to Accessory Drive Belt .
- See figure
- See figure
- Torque: 10 Nm
- See figure
- Torque: 40 Nm
- Torque: 12 Nm
- See figure
WARNING:
Make sure to support the vehicle with axle stands.
NOTE:
Some variation in the illustrations may occur, but the essential information is always correct.
NOTE:
Some variation in the illustrations may occur, but the essential information is always correct.
WARNING:
Fluid loss is unavoidable, use absorbent cloth or a container to collect the fluid.
CAUTION:
Engine coolant will damage the paint finished surfaces. If spilt, immediately remove the coolant and clean the area with water.
NOTE:
Engine shown removed for clarity.
CAUTION:
Note the fitted position of the component prior to removal.
CAUTION:
A new O-ring seal is to be installed.
NOTE:
Install new gaskets.
