LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Land Rover >> 2012 >> LR4 HSE Lux >> Repair and Diagnosis >> Body & Frame >> Exterior Body Panels >> Bumpers >> Bumpers >> Removal And Installation >> Rear Bumper Cover >> Removal

Rear Bumper Cover: Removal

    All vehicles 

    WARNING: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.
  1. Raise and support the vehicle.
  2. Remove both rear lamp assemblies. Refer to Rear Lamp Assembly .
  3. Remove both rear quarter panel mouldings. Refer to Rear Quarter Panel Moulding .
  4. Remove 4 screws, 2 clips and 2 bolts from the rear bumper cover.
    GJ0019590
  5. With assistance, remove 4 clips from the inner edge of the bumper cover.
    • Tilt the tailgate for access.
    • Open the tailgate hinge cover.
    GJ0019591
  6. Remove the rear bumper cover.
    • Release from the 12 clips.
    • If installed, disconnect the parking aid sensor wiring harness electrical connector.
    GJ0019592
    7. NOTE: Do not disassemble further if the component is removed for access only.
  7. Remove the towing eye cover.
    • Remove the 2 screws.
    GJ0015259
  8. Remove the rear bumper trim panel.
    • Release the 11 clips.
    GJ0019593
  9. Remove the bumper insert.
    • Remove the 3 screws.

    Vehicles with parking aid 

  10. Remove the parking aid sensor wiring harness.
    • Disconnect the 4 electrical connectors.
    GJ0019594

    11. Vehicles with parking aid 

  11. Remove the parking aid sensor.
    • Release the 2 clips.
    • Repeat the above procedure for the remaining 3 sensors.
    GJ0019377

    12. Vehicles with parking aid 

  12. Remove the parking aid sensor trim panel.
    • Release the 3 clips.
    • Repeat the above procedure for the remaining 3 sensor trim panels.
    GJ0019378
scientia non olet · About LEMON Manuals