LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Land Rover >> 2012 >> LR4 HSE Lux >> Repair and Diagnosis >> Accessories & Equipment >> Exterior Lights >> Exterior Lighting >> Exterior Lighting >> Removal And Installation >> Headlamp Assembly >> Installation

Headlamp Assembly: Installation

  1. Install the gas discharge module.
    • Connect the electrical connector.
    • Tighten the 2 screws.
  2. Install the gas discharge module cover.
    • Install the seal.
    • Tighten the screws.
  3. Install the turn signal indicator bulb.
    • Secure the bulb holder.
    • Install the cover.
  4. Install the side marker bulb.
    • Install the bulb holder.
  5. Install the side lamp bulb.
    • Install the bulb holder.
  6. Install the headlamp outer bulb.
    • Connect the electrical connector.
    • Install the cover.
    • Install the headlamp outer retaining clip.
    7. CAUTION: Make sure the seal is installed correctly.
  7. Install the headlamp inner bulb.
    • Secure with the clip.
    • Connect the electrical connector.
    • Install the cover.
    8. CAUTION: Make sure the seal is installed correctly.
  8. Install the headlamp bulb.
    • Secure with the clip.
    • Connect the electrical connector.
    • Install the cover.
  9. Install the headlamp assembly.
    • Connect the electrical connector.
    • Secure with the 2 clips.
  10. Install the radiator grille. Refer to Radiator Grille .
  11. Connect the battery ground cable. Refer to Specifications .
    12. NOTE: The headlamp setting is 1.2 % below horizontal and parallel.
  12. Check the headlamp beam alignment.
scientia non olet · About LEMON Manuals