High Mounted STOPLAMP: Installation
- See figure
- See figure
- See figure
- Refer to Specifications
.
CAUTION:
Make sure that the mating faces are clean and free of foreign material.
NOTE:
Apply etch primer to any bare metal, apply primer over the etch primer.
CAUTION:
Touching the adhesive surface will impair rebonding.
NOTE:
Apply activator to the high mounted stop lamp.
NOTE:
Apply an 8.0 mm wide continuous bead of sealant, 15.0 mm in, from the outer edge of the high mounted stoplamp.
CAUTION:
Make sure that the component is correctly located on the locating dowels.
CAUTION:
Make sure that no excess sealant residue is evident.
