Driver Air Bag Module: Removal
WARNING:
It is imperative that before any work is undertaken on the SRS system, the appropriate information is read thoroughly.
WARNING:
Always disconnect both battery cables before beginning work on the SRS system. Disconnect the ground cable first. Never reverse connect the battery.
NOTE:
If the SRS component is to be replaced, the bar code of the new unit must be recorded.
- Disconnect the battery ground cable. Refer to Specifications article.
- Make the SRS system safe. Refer to Standard Workshop Practices article.
- Remove the driver air bag module.
- Using the special tool, release the clip.
- Repeat the above procedure for the other side.
- Disconnect the ground cable.
- Release the clips and disconnect the 2 electrical connectors.
