Pinpoint Test C: Safety Belt Retractor-Webbing Guide Loose

Refer to REMOVAL AND INSTALLATION  remove any trim panels required to expose the D loop (anchor point) and safety belt retractor

Check the webbing is not trapped or twisted and is centrally located on the safety belt retractor spindle

Attempt to withdraw the webbing from the safety belt retractor NOTE: If the safety belt webbing is jammed, the automatic locking retractor could be engaged 

To release the automatic locking retractor, manually wind the webbing onto the spindle until the automatic locking retractor deactivates (clicking stops)

Fully extract webbing

Confirm webbing guide location is correct, Confirm the fixing lugs are correctly located in the retractor frame

Allow webbing to retract

Check for correct operation twice 

Does the webbing move freely then retract correctly? 

YES:  Refer to REMOVAL AND INSTALLATION  , reinstall any trim panels, ensure there are no obstructions and the webbing does not catch or rub. No further action required

NO:  Refer to Pinpoint Test D .