Transmission Fluid Level Check: Check
WARNING:
Observe due care when draining, as the fluid can be very hot.
WARNING:
Observe due care when working near a hot exhaust system.
NOTE:
Some variation in the illustrations may occur, but the essential information is always correct.
-
- The following steps must be observed before starting the transmission fluid level check.
- The vehicle must be on a horizontal ramp.
- The parking brake must be applied.
- The engine must be running for 2 minutes with the transmission control switch (TCS) in the "P" position.
- Connect the diagnostic tool to the vehicle.
-
- Start the engine.
- Apply, and hold, the footbrake.
- Move the selector lever from 'P' through all gear positions, pausing in each gear position for 2-3 seconds and return to the 'P' position.
- Raise and support the vehicle.
- Torque: 9 Nm
- Torque: 9 Nm
- Place a suitable container under the transmission fluid fill plug.
-
- Special Tool(s): 307-452
- Clean the area around the transmission fluid level plug.
WARNING:
Make sure to support the vehicle with axle stands.
WARNING:
Observe due care when draining, as the fluid can be very hot.
WARNING:
Observe due care when working near a hot exhaust system.
CAUTION:
The transmission fluid level must only be checked when the temperature of the fluid is between 30 degrees and 50 degrees. The fluid level obtained will be incorrect if the reading is outside this temperature range.
CAUTION:
Discard the seal.
