Transmission Fluid Drain And Refill: Filling
- Torque: 8 Nm.
-
- Refill the transmission with fluid.
- Use transmission fluid meeting Land Rover specification.
- Allow the transmission fluid to drain from the transmission fluid filler plug hole until the flow almost stops.
-
- Loosely install the transmission fluid fill plug.
-
- To make sure the transmission fill plug is torqued to the correct specification. Using the special tool and torque wrench the following calculation steps must be followed.
- Step 1. Multiply 35 Nm by the effective length of the torque wrench (1).
- Step 2. Add the effective length of the special tool (2) to the effective length of the torque wrench (1).
- Step 3. Divide the total of step 1 by the total of step 2.
- Step 4. Set the torque wrench to the figure arrived at in step 3.
- Tighten the transmission fluid fill plug to the torque given by the calculation.
- Carry out a transmission fluid level check. Refer to TRANSMISSION FLUID LEVEL CHECK .
- Torque: 9 Nm.
- Torque: 9 Nm.
- Lower the vehicle.
NOTE:
Install a new sealing washer.
CAUTION:
Make sure the transmission fluid fill plug is tightened to the correct specification. Failure to follow this instruction may result in damage to the vehicle.
