LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Land Rover >> 2012 >> LR4 HSE Lux >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transmission/Transaxle >> Automatic Transmission/Transaxle (V8 5.0L Petrol/TDV6 3.0L Diesel) >> Removal And Installation >> Transmission Fluid Pan, Gasket And Filter >> Installation

Transmission Fluid Pan, Gasket And Filter: Installation

    CAUTION: Make sure that when fully fitted, all seals protrude by the same amount.
    CAUTION: Install the new seals.
    • Install a new seal block.
    GJ0013889
    2. CAUTION: Install the new seals.
    CAUTION: Make sure that when fully fitted, all seals protrude by the same amount.
  2. See figure.
    GJ0013888
  3. Install the new gasket.
  4. Install the transmission fluid pan and the transmission control module.
    5. CAUTION: Make sure the manual park release is correctly engaged.
    NOTE: Transmission fluid pan shown removed for clarity.
  5. Tighten to 8 Nm.
    GJ0013887
    6. CAUTION: Make sure that a new component is installed.
  6. See figure.
    GJ0013890
  7. See figure.
    GJ0013891
  8. See figure.
    GJ0013884
  9. Tighten to 8 Nm.
    GJ0013897
  10. See figure.
    GJ0013895
  11. See figure.
    GJ0013894
  12. See figure.
    GJ0013260
    13. NOTE: Install a new gasket.
  13. Tighten to 22 Nm.
    GJ0012568
  14. Tighten to 22 Nm.
    GJ0011952
  15. See figure.
    GJ0013893
  16. See figure.
    GJ0013892
  17. Refer to Transmission Support Crossmember - 5.0L article.
  18. See Transmission Fluid Drain and Refill .
  19. Lower the vehicle.
scientia non olet · About LEMON Manuals