LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Land Rover >> 2012 >> LR4 HSE Lux >> Repair and Diagnosis >> Drivelines & Axles >> Driveshaft & Universal Joints >> Driveshaft >> Removal And Installation >> Rear Driveshaft >> Removal

Rear Driveshaft: Removal

NOTE: A small amount of oil may weep from the driveshaft joints during storage. The loss of this oil will not affect the operation or durability of the joint.
    WARNING: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.
  1. Raise and support the vehicle.
  2. Remove the fuel tank heat shield.
    • Remove the 3 bolts and 2 nuts.
      GJ0013186
    3. CAUTION: Mark the position of the driveshaft flange in relation to the drive pinion flange.
    CAUTION: To avoid damage to the joint or gaiter, do not allow the driveshaft to hang.
  3. Release the driveshaft from the transfer case drive flange.
    • Remove the 6 Torx bolts and washers.
      GJ0013176
    4. CAUTION: Mark the position of the driveshaft flange in relation to the drive pinion flange.
    CAUTION: To avoid damage to the joint or gaiter, do not allow the driveshaft to hang.
  4. Release the driveshaft from the rear axle drive flange.
    • Remove and discard the 4 Torx bolts.
      GJ0014537
  5. With assistance, remove the driveshaft.
    • Remove the 2 driveshaft center bearing mount bolts.
      GJ0013187
scientia non olet · About LEMON Manuals