Transfer Case V6 4.0L Petrol: Installation
- With assistance, install the transfer case.
- Clean the component mating faces.
- Lubricate input shaft splines with 'Weicon TL7391' grease.
- Install the O-ring seal.
- Align the fuel hose support bracket.
- Using the special tool, tighten the bolts to 45 Nm (33 lb.ft).
- Connect the breather line.
- Position the fuel line support bracket.
- Tighten the bolts to 10 Nm (7 lb.ft).
- Secure the fuel lines.
- Position the selector cable to its guide bracket.
- Connect the electrical connectors.
- Secure the wiring harness to the transfer case.
- Secure with the clip.
- Tighten the bolts to 25 Nm (18 lb.ft).
- Install the transmission support insulator.
- Clean the component mating faces.
- Tighten the bolts to 60 Nm (44 lb.ft).
- Install the rear driveshaft. Refer to Rear Driveshaft .
- Install the front driveshaft. Refer to Front Driveshaft - 4.0L .
- Connect the battery ground cable. Refer to Specifications .
- Use T4 to re-calibrate a new transfer case.
