Front Wheel Bearing And Wheel Hub: Installation
- Clean the components.
- Install the wheel hub.
- Using the special tools, install the halfshaft in the wheel hub.
- Tighten the 4 bolts to 115 Nm (85 lb.ft).
- Install a new halfshaft retaining nut and lightly tighten.
- Make sure the brake disc and hub mating surfaces are clean.
- Install the brake disc.
- Tighten the Torx screw to 35 Nm (26 lb.ft).
- Install the brake caliper and anchor plate.
- Install the wheel speed sensor.
- Tighten the bolts to 275 Nm (203 lb.ft).
- Install the wheel speed sensor retaining bolt.
- Secure the brake hose retaining bracket to the wheel knuckle.
- Tighten the bolt to 22 Nm (16 lb.ft).
- Tighten the new halfshaft retaining nut to 230 Nm (170 lb.ft).
- Stake the nut to the halfshaft.
- Depress the brake pedal several times, check the fluid level in the brake fluid reservoir and top-up with brake fluid if necessary.
- Install the wheel and tire.
- Tighten the wheel nuts to 140 Nm (103 lb.ft).
CAUTION:
Do not use air tools to install the nut. Failure to follow this instruction may result in damage to the component.