Shock Absorber And Spring Assembly: Installation
- Install the shock absorber and spring assembly.
- Make sure the spring and shock absorber assembly top mounting to body mating faces are clean.
- Fit the nuts and tighten to 63 Nm (46 lb.ft).
- Secure the heat shield.
- Install the three retaining bolts and tighten to 10 Nm (7 lb.ft).
- Connect the shock absorber and spring assembly to the lower arm.
- Tighten the nut and bolt to 300 Nm (221 lb.ft).
- Install the fender splash shield. Refer to Fender Splash Shield article.
- Install the wheel and tire.
- Tighten the wheel nuts to 140 Nm (103 lb.ft).
- Refer to Air Suspension System Depressurize and Pressurize article.