Lower Arm: Installation
- Install the lower arm.
- Fit the bolts but do not fully tighten at this stage.
- Connect the lower arm to the wheel knuckle.
- Tighten the lower arm ball joint retaining nut to 115 Nm (85 lb.ft).
- Set the height distance between the center of the halfshaft end and the edge of the fender trim to 466 mm (18.34").
- Tighten the lower arm bolts to 275 Nm (203 lb.ft).
- Align the bolts to the marks made previously.
- Connect the shock absorber and spring assembly to the lower arm.
- Tighten the nut and bolt to 300 Nm (221 lb.ft).
- Install the wheel and tire.
- Tighten the wheel nuts to 140 Nm (103 lb.ft).
- Carry out the wheel alignment procedure.
CAUTION:
The lower arm ball joint can be damaged by excessive articulation. Do not over articulate the ball joint. Failure to follow this instruction will result in damage to vehicle.
