Upper Arm Bushing: Installation

CAUTION: Make sure the correct special tool is used to install the bushings to the correct depth.

Using the special tools, install the upper arm rear bushings.
- Align the arrow on the bush with the mark, previously made on the upper arm.
Using the special tools, install the upper arm front bushings.
- Align the arrow on the bush with the mark, previously made on the upper arm.
Install the RH upper arm.
- Fit the bolts but do not fully tighten at this stage.
Secure the brake hose to the upper arm.
- Tighten the bolt to 23 Nm (17 lb.ft).
Secure the wheel speed sensor lead to the upper arm.
Connect the upper arm and wheel knuckle.
- Install a new nut and tighten to 70 Nm (52 lb.ft).
Secure the stabilizer bar link.
- Install a new nut and tighten to 115 Nm (85 lb.ft).
Connect the height sensor link arm.
Set the height distance between the center of the halfshaft end and the edge of the fender trim to 466 mm (18.34").
Tighten the 2 upper arm nuts and bolts to 175 Nm (129 lb.ft).
Secure the heat shield.
Install the LH upper arm. See Upper Arm .
Install the front wheels and tires.
- Tighten the wheel nuts to 140 Nm (103 lb.ft).